Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
sansa_fuze [2017/08/01 00:57] beandog |
sansa_fuze [2018/09/01 19:20] beandog |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| <code> | <code> | ||
| - | avconv -y -i video.mp4 -vcodec mpeg2video -s 220x176 -vb 384k -acodec mp3 -ab 96k -o video.mpg | + | avconv -i video.mp4 -vcodec mpeg2video -s 220x176 -vb 384k -acodec mp3 -ab 96k -y video.mpg |
| </code> | </code> | ||
| Line 40: | Line 40: | ||
| sudo ./fsck.fat -r -l -v -t -y /dev/sansa | sudo ./fsck.fat -r -l -v -t -y /dev/sansa | ||
| </code> | </code> | ||
| + | |||
| + | ==== Rockbox ==== | ||
| + | |||
| + | Building RockBox from source isn't too bad ... if you're patient. :) | ||
| + | |||
| + | Download 3.14 source code [[http://download.rockbox.org/release/3.14/rockbox-3.14.7z|here]] and unpack it. | ||
| + | |||
| + | cd into ''tools/'', and set proper permissions for executable files: | ||
| + | |||
| + | <code> | ||
| + | chmod +x *.pl *.sh configure genlang | ||
| + | </code> | ||
| + | |||
| + | Run ''configure'', the architecture type is ARM. | ||
| + | |||
| + | Make a build dir outside of the tools directory, and run ''configure''. | ||
| + | |||
| + | <code> | ||
| + | mkdir ../build | ||
| + | cd ../build | ||
| + | ../tools/configure | ||
| + | </code> | ||
| + | |||
| + | The target for the Sansa Fuze is 58. | ||
| + | |||
| + | Run ''make'' as normal to build the install! | ||
